Pages

Wednesday, July 12, 2017

FTTH BDCOM OLT Laser Check and New ONU Client Configure


BDCOM-OLT ONU Laser check and Reboot::
------------------------------------
New_OLT# show epon active-onu
EPON0/2:45 2057.af00.97b3 registered
New_OLT# show epon optical-transceiver-diagnosis | include EPON0/2:45
epon0/2:45   -19.4
New_OLT# epon reboot onu interface EPON0/2:45
Are you sure to reboot the ONU(y/n)?

New Client allow(activate) from Command prompt by BDCOM OLT:
-----------------------------------------------------------
If we want to add a client under PON2 with ONU MAC  ab:cd:f7:18:12:34 with our predefined valn 20 using last serial number 5 and assigned

10Mb bandwidth to ONU

FTTH#config
FTTH_config#interface EPON 0/2
epon bind-onu mac abcd.f718.1234 5
FTTH_MIRPUR_config#interface ePON 0/2:5
FTTH_MIRPUR_config_epon0/2:5#
onu-configuration
  epon onu port 1 ctc vlan mode tag 21
  epon onu port 2 ctc vlan mode tag 21
  epon onu port 3 ctc vlan mode tag 21
  epon onu port 4 ctc vlan mode tag 21
  epon onu port 1 ctc rate-limit 10240 ingress
  epon onu port 1 ctc rate-limit 10240 egress
  epon onu port 2 ctc rate-limit 10240 ingress
  epon onu port 2 ctc rate-limit 10240 egress
  epon onu port 3 ctc rate-limit 10240 ingress
  epon onu port 3 ctc rate-limit 10240 egress

FTTH_config_epon0/2:5#exit
FTTH_config#exit
FTTHR#write

3 comments:

  1. need help to change 10g interface speed

    ReplyDelete
  2. need help to change 10g interface to 1G spped
    in BDCOM OLT 3600

    ReplyDelete
  3. Additionally new laser etchers can imprint words and pictures on for all intents and purposes any kind of material. This is the reason little shop and entrepreneurs are currently doing custom mechanical and innovative work that they never would have imagined conceivable previously.co2 laser cutter

    ReplyDelete